235.1 Adding User CodesSimplified sequences for adding codes are given in sections 5.1.1, 5.1.2and Appendix B.To add a user code use one of the following sequences:- = the new code being added. = Sets the level of new code being added, 1 = Standarduser, 2 = Primary user, 3 = Manager. If this field is omitted then thecode is added as a standard user.1 = Lock Relay, 2 = Auxiliary Lock Relay, 3 = Both Lock & Auxiliary LockRelays. If this field is omitted then the code operates the Lock Relay.NOTE if the Auxiliary relay output is not set as a secondary lockcontroller then all user programmed codes will control the Lock relayregardless of the The Status LED indicates the stage you are at during the adding a codesequence, as shown below:-
