Nidac 1 Series Instruction Manual
                                    | |
Contents
| 
42 INSTALLATION2.1 MOUNTING1. Use the supplied template to mark the location of the cable exit andmounting screws. Drill out all points as necessary.2. Using the supplied key remove the hex Allen screw(s) at the bottomof the keypad that secure the fascia to the chassis.3. Swing the fascia up from the bottom and it will unhook at the topallowing access to the mounting screw holes.4. Attach the supplied cable by plugging in the connector (you mayneed to use a screw driver to push the connector around the edgesto ensure it is in firmly). Note that it is designed to be inserted in oneway only; however use of excessive force could allow it to beinserted wrongly so check the guide locators match before inserting.5. Slide the rubber boot down the cable and press the first flange intothe hole and leaving the second flange on the outside of the keypad.Make sure that it sits neatly in all places to ensure a correct seal.6. Mount the keypad and reverse steps 2 & 3 to reattach the fascia tothe keypad chassis. |
Related manuals for Nidac 1 Series
manualsdatabase
Your AI-powered manual search engine