Nidek Medical LEX-DRILL Service Manual
                                                                                              | |
Contents
| 
LHM2A*RDA001A/E6 - 146.26 V Axis SensorReplacement part: V axis sensor (44101-CA10)1. Remove the right cover (44101-M202), leftcover (44101-M203), top cover ASSY. (44101-2100), and washer (44101-M206) (see 5.3).2. Disconnect the cable connector (P203) fromthe V axis sensor (44101-CA10).3. Unscrew CK2 × 4 (n = 2) and PW2 (n = 2) toremove the V axis sensor.4. Reassemble the parts in reverse order.1) Calibration of the shading plate positionis necessary (see 7.4.1).6.27 θθθθθ Axis SensorReplacement part: θ axis sensor (44101-CA11)1. Remove the right cover (44101-M202), leftcover (44101-M203), top cover ASSY. (44101-2100), and washer (44101-M206) (see 5.3).2. Disconnect the cable connector (P205) fromthe θ axis sensor (44101-CA11).3. Unscrew CK2 × 4 (n = 2) and PW2 (n = 2) toremove the θ axis sensor.4. Reassemble the parts in reverse order.1) Calibration of the shading plate positionis necessary (see 7.4.1).6.28 Chuck SW SensorReplacement part: Chuck SW sensor (44101-CA12)1. Remove the right cover (44101-M202), leftcover (44101-M203), top cover ASSY. (44101-2100), and washer (44101-M206) (see 5.3).2. Disconnect the cable connector (P207) fromthe chuck SW sensor (44101-CA12).3. Unscrew CK2 × 4 (n = 2) to remove the chuckSW sensor.4. Reassemble the parts in reverse order.1) Calibration of the shading plate positionis necessary (see 7.4.1).2CK2×4PW2 2CA102CK2×4CA112CK2×8CA12 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine