5 Connecting PMC Network Interface Cards64 Nokia 105s Gateway Installation Guide Packet tracing for analysis through tcpdump Compliance with IEEE 802.3ab Gigabit Ethernet specificationFigure 13 shows the front panel details for the two-port copper GigabitEthernet NIC you use in the Nokia 105s gateway.Figure 13 Two-Port Copper Gigabit Ethernet NICCopper Gigabit Ethernet Connectors and CablesThe copper Gigabit Ethernet NIC receptacles use RJ-45 connectors.To connect to a 1 Gbps hub, switch, or router, use a straight-through RJ-45cable (Cat 5 type cable, or as required by your network configuration).NoteAll Nokia copper Gigabit Ethernet NICs support cable auto-sensing. Youcan use a straight-through or crossover cable to connect the NIC to aGigabit Ethernet hub or switch, or to connect directly to a host.In Figure 14, the RJ-45 cable output connector is numbered from right to left,with the copper pins facing up and toward you.00386.5LINKACTV2LINKACT1000BaseTLink LED (solid yellow for 10/100 Mbps, solid green for 1000 Mbps)Activity LEDs (blinking yellow)RJ-45 connectors
