Ethernet Connection Fault Management194"FD 100/320Gbps NT and FX NT IHub SystemBasics, Management and OAM Guide"3HH-11982-AAAA-TQZZA Issue: 108.12.2.5 single-ended-loss-testTable 225 single-ended-loss-test command8.12.3 Show Commands8.12.3.1 associationTable 226 association commandItem DescriptionSyntax single-ended-loss-test mac-address mep mep-id domain md-index association ma-index[priority priority] [interval {1s}] [send-count send-count]Context oam>eth-cfmDescription This command specifies to initiate a loss measurement test between the specifiedmac-address and the specified mep-id MEP.Parameters The parameters with their values and defaults are as follows:• mac-address — Specifies a unicast destination MAC address.Values: xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx, where xx is a hexadecimal number.• mep mep-id — Specifies the local mep-id.Values: 1 — 8191• md-index — Specifies the index of the MD to which the MEP is associated, or 0, if none.Values: 1 to 4294967295• ma-index — Specifies the index to which the MEP is associated, or 0, if none.Values: 1 to 4294967295• send-count — Specifies the number of LMM messages to send, expressed as a decimalintegerValues: 2 to 5Default: 2• interval {1s} — Specifies the interval between groups of consecutive LMM packets (forexample, if send-count is 5 and interval is 1s, then 5 LMM packets are sent at 1-s intervals)Values: 1sDefault: 1s• priority — Specifies the priorityValues: 0 to 7Default: 7Item DescriptionSyntax association [ma-index] [detail]Context show>eth-cfmDescription This command displays eth-cfm association information.(1 of 2)
