Monitor Commands78"FD 100/320Gbps NT and FX NT IHub SystemBasics, Management and OAM Guide"3HH-11982-AAAA-TQZZA Issue: 105.2.1 Monitor CLI Commandmonitor— filter— ip ip-filter-id entry entry-id [interval seconds] [repeat repeat] [absolute | rate]— ipv6 ipv6-filter-id entry entry-id [interval seconds] [repeat repeat] [absolute | rate]— mac mac-filter-id entry entry-id [interval seconds] [repeat repeat] [absolute | rate]— lag lag-id [lag-id...(up to 5 max)] [interval seconds] [repeat repeat] [absolute | rate]— port port-id [port-id...(up to 5 max)] [interval seconds] [repeat repeat] [absolute | rate]— router [router-id]— bgp— neighbor ip-address [ip-address...(up to 5 max)] [interval seconds] [repeat repeat] [absolute |rate]— isis— statistics [interval seconds] [repeat repeat] [absolute | rate]— ldp— session ldp-id [ldp-id...(up to 5 max)] [interval seconds] [repeat repeat] [absolute | rate]— statistics [interval seconds] [repeat repeat] [absolute | rate]— ospf— interface interface [interface...(up to 5 max)] [interval seconds] [repeat repeat] [absolute |rate]— neighbor ip-address [ip-address...(up to 5 max)] [interval seconds] [repeat repeat] [absolute |rate]— rip— neighbor neighbor [neighbor...(up to 5 max)] [interval seconds] [repeat repeat] [absolute |rate]— service— id service-id— sdp {sdp-id[:vc-id] | far-end ip-address} [interval seconds] [repeat repeat] [absolute | rate]5.3 Monitor CLI CommandsThe following commands are described below:• Filter Commands• LAG Commands• Port Commands• Router Commands• Service Commands5.3.1 Filter Commands5.3.1.1 filterTable 90 filter commandItem DescriptionSyntax filterContext monitor(1 of 2)
