2130 Nokia Network Voyager for IPSO 4.0 Reference GuideNoteIn VRRP configurations, configuring proxy ARP using static NAT addresses and interfaceMAC addresses is not supported.To delete a static ARP entry1. Click ARP under Configuration > Interface Configuration in the tree view.2. Click the checkbox in the Delete column next to the table entry to delete.Click Apply.3. Click Save to make your changes permanent.To view dynamic ARP entries1. Click ARP under Configuration > Interface Configuration in the tree view.2. Click the Display or Remove Dynamic ARP Entries link.To delete dynamic ARP entries1. Click ARP under Configuration > Interface Configuration in the tree view.2. Click the Display or Remove Dynamic ARP Entries link.3. Click the check box in the Delete column next to the ARP entry to delete.Click Apply.To flush all dynamic ARP entries1. Click ARP under Configuration > Interface Configuration in the tree view.2. Click Flush.Configuring ARP for ATM InterfacesTo change InATMARP global parametersThe InATMARP protocol is used for finding a mapping from IP addresses to ATM PVCs in alogical IP subnet (LIS) on top of an ATM network.1. Click ARP under Configuration > Interface Configuration in the tree view.2. Enter a value for one or more of the Keep Time, Timeout, Retry Limit and Holdoff Timeparameters in the corresponding fields in the Global InATMARP Settings table. Keep Time specifies time, in seconds, to keep resolved dynamic ATM ARP entries. Therange of Keep Time value is 1 to 900 seconds (15 minutes). Timeout specifies an InATMARP request retransmission interval in seconds. NetworkVoyager enforces that the timeout must be less than a third of Keep Time. The Range ofTimeout value is 1 to 300 with a default value of five seconds.
