Nokia Network Voyager for IPSO 4.0 Reference Guide 2214. Enter a password for the user cadmin.The password must have at least six characters.NoteYou must use the same password on each node that you add to the cluster. This is alsothe password that you use to log into Cluster Voyager or the CCLI.5. Enter the password for cadmin again (for verification).6. Click Apply.7. Click Manually Configure IPSO Cluster.Configure the cluster as explained in the following sections.Selecting the Cluster ModeSelect the cluster mode that is appropriate for your scenario: If the routers and switches on either side of the cluster support multicast MAC addresses,you can use multicast mode or multicast mode with IGMP. These modes usually offer betterthroughput because they make better use of the bandwidth of the production networks.NoteYou must use one of the multicast modes if you use PIM in the cluster. If the routers or switches adjacent to the cluster do not support multicast MAC addresses,you must use forwarding mode.CautionDo not use forwarding mode if you use PIM in the cluster.Configuring the Work Assignment MethodA cluster initially balances its work load by automatically distributing incoming traffic betweenthe nodes. Use the work assignment setting to govern whether the cluster can rebalance the loadof active connections by moving them between nodes. For optimum load balancing, use the dynamic setting. This setting allows the cluster toperiodically rebalance the load by moving active connections between nodes. Setting the work assignment to static prevents the cluster from moving active connectionsbetween nodes. It does not ensure stickiness or connection symmetry.You must use static work assignment if you use any of the following NGX features: Floodgate-1.
