A CCESS G ATEWAY360 TroubleshootingManagement Interface Error MessagesThe following table contains the error messages associated with the Management Interface(CLI and Web). All messages are listed alphabetically.Error Message CauseAAA must be enabled before adding asubscriber to the profile database.You are attempting to add a subscriber profilewhile AAA is disabled.Command not available “xx” The system does not recognize yourcommand (“xx” denotes your input).Current settings were not archived. This message is displayed if you answer “no”when prompted to overwrite the configurationarchive file with new settings.Current settings were not changed. This is either a response to your decision notto change settings, or the message isgenerated by the system when it fails to locatethe data it needs.Error loading factory settings. The system cannot find the defaultconfiguration file when attempting to restorethe factory settings.Error occurred, ARP entry not added. The IP or MAC address is invalid. Ensure thatyou input the correct format for these fields.NFS client support not included. This message is displayed when the systemreboots and NFS clients are not supported.No matching MAC address found in profiledatabase.The system could not match the MAC addressyou defined while attempting to remove asubscriber profile.[not defined] This is the factory default for some systemparameters.The system must be reset to function properly.The system must be rebooted to functionproperly!You have made changes to the system’sconfiguration that requires you to rebootbefore your changes become effective.