A CCESS GATEWAYInstalling the Access Gateway 61Enter new system location: Office, Newbury Park, CAEnter read/get community [public]:Enter write/set community [private]:Enter IP of trap recipient [0.0.0.0]: 10.11.12.13SNMP Daemon: EnabledSystem contact: newname@domainname.comSystem location: Office, Newbury Park, CAGet (read) community: publicSet (write) community: privateTrap recipient: 10.11.12.13Reboot to enable new changes? [yes/no] yRebooting...You can now address the Access Gateway using an SNMP client manager.Configuring the WAN interfaceNSE releases 8.2 and later add the following configuration steps.If a license key is not present, you will still be directed to set up the WAN configuration assoon as you log into the CLI.However, the subsequent steps are new and network settings areno longer configured under Location.The following are the steps are needed to configure the main WAN interface:1. Enter c (configuration) at the Access Gateway Menu. The Configuration menu appears.2. Enter eth (ethernet).1. After you have entered “yes” to the initial prompt, enter “mod int WAN” or “m i WAN”(“modify interface WAN”). Note that modes and interface names are case sensitive. Theconfiguration then steps through the settings one by one.2. Port role for the WAN port should be already set to WAN, just hit 3. Set the configuration mode to match your network settings.4. Set the remaining network settings .5. Default uplink and download speed is 15 Mbps. Enter different values if desired.In NSE releases 8.2 and later, bandwidth and DNS settings are configured separately foreach WAN interface. You can configure them later in the WAN configuration dialog in theWeb Management Interface.6. If you do not wish to configure additional NAT IP addresses at this time, type “b”.7. A summary of the WAN port settings is now displayed; if they are correct, type “b” again.
