Nortek 2GIG GC3 Installation And Programming Manual
Also see for 2GIG GC3: User guideUser guideInstallation and programming guideUser guide
                                                                                            | |
Contents
| 
Copyright © 2019 Nortek Security & Control LLC88Adding a Demo VideoDemo ModeThe Demo Mode allows a dealer to add a Demo Video tothe panel.To add a Demo Video:1. Navigate to the Installer Toolbox and tap DemoMode.Installer Toolbox - Demo Mode2. Copy an mp4 video onto a USB drive.Notes:» File size - cannot exceed 200mb» Recommended Resolution - 720p/30 framesper second, not to exceed 20Mbps3. Insert the USB drive into the top of the panel.4. Press the Replace Video button.Demo Mode - Replace VideoVerify the Radio StatusAfter installing the Cellular Radio Module for the first time,perform a radio test to check the cell signal strength,confirm the serial number of the module, and view otherinformation about the cellular radio connection. This is ahelpful tool to use when troubleshooting the installation.To open the Radio Test menu, navigate to the InstallerToolbox. Then tap Radio Test. At the Radio Statusscreen, tap Start Radio Test.When the test is complete:» A “Success” message indicates the module isfunctioning properly (see next image).» A “Cell Radio Module Status Not Detected” messageindicates a module is not properly installed. See“Install/Replace the Cellular Radio Module.”» A “Remote Services Provider is Not Set” messageindicates that the installer has not programmed aRemote Services Provider for the GC3 Panel. See“Q7: Remote services provider.”Installer Toolbox—Radio Status Test Success |
Related manuals for Nortek 2GIG GC3
manualsdatabase
Your AI-powered manual search engine