Windows 2000 server reference 227CS 1000 Telephony Manager Installation and Configuration7 Ensure that all changes are saved and the server restarted. When the serverrestarts, check that all settings are applied. Launch a command prompt window andcheck the routing table using the "route print" command. The interface metric valuehas changed.Installing a modemProcedure 56Installing a modemFollow the procedure below to install a modem on a Windows server:1 Choose Start > Settings > Control Panel.2 Double-click the Phone and Modem Options icon.3 In the Phone and Modem Options dialog box, click the Modems tab.4 If the modem on the computer is not already installed, click Add.If the modem is attached to the computer, Windows can detect and install a modemautomatically.5 In the Install New Modem dialog box, click Next to continue.6 If the system is unable to detect the modem, you must insert the modemmanufacturer’s disk that came with the modem, and then select Have disk to install.7 If the system does not have a modem attached, select Standard 28800 bps Modemfrom the list.8 Click Finish to close the dialog box.End of ProcedureInstalling Remote Access ServiceProcedure 57Installing Remote Access ServiceFollow the procedure below to install Remote Access Service (RAS) on a Windowsserver:1 Choose Start > Settings > Network and Dialup Connections.2 Double-click the Make New Connection icon.3 In the Network Connection Wizard welcome dialog box, click Next.4 In the Network Connection Type dialog box, select Accept incomingconnections, and then click Next.
