Nortel 4524GT Configuration

Also see for 4526FX: Overview-System Configuration Installation guide Installation Product information

Contents

Nortel 4524GT Configuration Manual pdf 44 page image

44 Chapter 2 Configuring Quality of Service (QoS) with the CLIParameter Descriptiondiag [mask | resource] Displays the diagnostics entries. Mask displaysthe QoS mask precedence use, and resourcedisplays the QoS resource use.ip-acl <1 - 65535> Displays the specified IP access list assignmententry.l2-acl <1 - 65535> Displays the specified Layer 2 access listassignment entry.capability [meter | shaper][port ]Displays QoS meter or shaper port capabilities.The show qos command is executed in the Privileged EXEC commandmode.Configuring QoS Access ListsThe CLI commands described in this section allow for the configurationand management of QoS access lists. For information on displaying thisinformation, refer to "Displaying QoS Parameters" (page 39).qos acl-assign commandThe qos acl-assign command is used to assign ports to an access list.The syntax for the qos acl-assign command isqos acl-assign [<1 - 55000>] [enable][port ]acl-type {ip | l2}name "qos acl-assign parameters" (page 44) outlines the parameters for thiscommand.qos acl-assign parametersParameter Description<1 - 55000> A unique identifier for the access list assignment.enable Enable the access-list assignment entry.port The list of ports assigned to the specified access list.acl-type {ip | l2} The type of access list used; IP or Layer 2.name The name of the access list to be used. Access listsmust be configured before ports can be assigned tothem. Refer to "qos ip-acl command" (page 45) and"qos l2-acl command" (page 46) for information onperforming these tasks.Nortel Ethernet Routing Switch 4500 SeriesConfiguration — Quality of ServiceNN47205-504 (322816-B) 03.01 Standard5.1 23 November 2007Copyright © 2007, Nortel Networks.