52 Chapter 2 Configuring Quality of Service (QoS) with the CLIdefault qos egressmap commandThe default qos egressmap command resets the egress mappingentries to factory default values.The syntax for the default qos egressmap command isdefault qos egressmapThe default qos egressmap command is executed in the GlobalConfiguration command mode.qos ingressmap commandThe qos ingressmap command configures 802.1p priority-to-DSCPassociations that are used for assigning default values at packet ingressbased on the 802.1p value in the ingressing packet.The syntax for the qos ingressmap command isqos ingressmap [name ] 1p <0-7> ds <0-63>"qos ingressmap parameters" (page 52) outlines the parameters for thiscommand.qos ingressmap parametersParameter Descriptionname Specify the label for the ingress mapping.1p <0-7> Enter the 802.1p priority used as lookup key for DSCPassignment at ingress; range is between 0 and 7.ds <0-63> Enter the DSCP value associated with the target 802.1ppriority; range is between 0 and 63.The qos ingressmap command is executed in the Global Configurationcommand mode.default qos ingress commandThe default qos ingressmap command resets the ingress mappingentries to factory default values.The syntax for the default qos ingressmap command isdefault qos ingressmapThe default qos ingressmap command is executed in the GlobalConfiguration command mode.Nortel Ethernet Routing Switch 4500 SeriesConfiguration — Quality of ServiceNN47205-504 (322816-B) 03.01 Standard5.1 23 November 2007Copyright © 2007, Nortel Networks.
