Configuring QoS Meters 67The no qos if-action-extension command is executed in the GlobalConfiguraton command mode.Configuring QoS MetersUsing the following CLI commands to set the meters, if you want to meter orpolice the traffic, configure the committed rate, burst rate, and burst duration.qos meter commandThe qos meter command creates QoS meter entries.The syntax for the qos meter command isqos meter <1-55000> [name ] [committed-rate<64-32000000>] [burst-size ] [max-burst-rate<64-4294967295>] [max-burst-duration <1-4294967295>]{in-profile-action <1-55000> | in-profile-action-name} {out-profile-action <1,9-55000> |out-profile-action-name } [session-id <1-4294967295>]"qos meter parameters" (page 67) describes the parameters for thiscommand.qos meter parametersParameter Description<1-55000> Enter an integer to specify the QoS meter;range is 1 to 55000.name Specify name for meter; maximum is 16alphanumeric characters.committed-rate<64-32000000>Specifies rate that traffic must not exceed forextended periods to be considered in-profile.Enter the rate in Kb/s for in-profile traffic inincrements of 1000 Kbits/sec; range is 64 to32000000 Kbits/sec.burst-size Committed burst size in Kilobytes. The valuerange is: 4, 8, 16, 32, 64, 128, 256, 512, 1024,2048, 4096, 8192, 16384.max-burst-rate<64-4294967295>Specifies the largest burst of traffic that canbe received a given time for the traffic to beconsidered in-profile. Used in calculating thecommitted burst size. Enter the burst sizein Kb/s for in-profile traffic; range is 64 to4294967295 Kbits/secNortel Ethernet Routing Switch 4500 SeriesConfiguration — Quality of ServiceNN47205-504 (322816-B) 03.01 Standard5.1 23 November 2007Copyright © 2007, Nortel Networks.
