68 Chapter 2 Configuring Quality of Service (QoS) with the CLIParameter Descriptionmax-burst-duration<1-4294967295>Specifies the amount of time that the largestburst of traffic that can be received for the trafficto be considered in-profile. Used in calculatingthe committed burst size. Enter the burstduration in ms for in-profile traffic; range is 1 to4294967295 ms.in-profile-action <1-55000> Specify the in-profile action ID; range is 1 to55000.in-profile-action-nameSpecify the in-profile action name.out-profile-action-nameSpecify the out-profile action name.out-profile-action<1,9-55000>Specify the out-of-profile action ID; range is 1,9to 55000.session-id <1-4294967295> Specify the session ID.The qos meter command is executed in the Global Configurationcommand mode.ATTENTIONIn case committed rate is not a multiple of 64, this value is rounded down to thehighest multiple of 64, smaller than committed rate. For example, a committedrate of 1000 kbps is automatically rounded down to 960 kbps.no qos meter commandThe no qos meter command deletes QoS meter entries.The syntax for the no qos meter command isno qos meter <1-55000>Substitute <1-55000> above with the ID of the QoS meter to be deleted.The no qos meter command is executed in the Global Configurationcommand mode.ATTENTIONA meter that is referenced in an installed policy cannot be deleted.Nortel Ethernet Routing Switch 4500 SeriesConfiguration — Quality of ServiceNN47205-504 (322816-B) 03.01 Standard5.1 23 November 2007Copyright © 2007, Nortel Networks.
