|
56 Chapter 2 Configuring Quality of Service (QoS) with the CLIDeleting a classifier, classifier block, or an entire filter setTo delete an entire filter set, use the following command from the Globalconfiguration mode:no qos nsna name where is the label used to reference the Nortel SNA entry.To delete a classifier, use the following command from the Globalconfiguration mode:no qos nsna name eval-order where is the label used to reference the Nortel SNA entryand is the evaluation order identifier that references the specificNortel SNA entry.To delete a classifier block, use the command for deleting a classifier todelete all the classifier members in that block.Note: You cannot delete all the classifiers in a filter set. There shouldalways be at least one remaining.Configuring QoS Elements, Classifiers, and Classifier BlocksElements, classifiers, and classifier blocks can be configured using the CLI.This section covers the CLI following commands.qos ip-element commandThe qos ip-element command adds IP classifier element entries.The syntax for the qos ip-element command isqos ip-element [addr-type ][src-ip][dst-ip ][ds-field][protocol ][src-port-min src-port-max ][next-header ][dst-port-min dst-port-max ] [session-id ]"qos ip-element parameters" (page 56) outlines the parameters for thiscommand.qos ip-element parametersParameter Description Enter an integer to specify the element ID. Theallowable range of values is 1 to 55000.addr-type Specify the address type, either ipv4 or ipv6.Default is ipv4.Nortel Ethernet Routing Switch 4500 SeriesConfiguration — Quality of ServiceNN47205-504 (322816-B) 03.01 Standard5.1 23 November 2007Copyright © 2007, Nortel Networks.
|
