LAN advanced configuration 103Configuration GuideWLAN radio configuration parametersThe following section describes the parameters for configuration of the WLAN radio located atConfiguration, LAN, Wireless, Radio tab.Variable definitionsThe following table describes the variables and values for configuring the WLAN radio.VLAN Identifier Type the VLAN ID to which SSID users belong. Access points use thisVLAN ID to tag the packets from the specified users of the given SSID.Status When you configure an SSID, this field appears in the new row. It specifiesthe activation status of the WLAN SSID. The configured SSID is addedwith a default status of Enabled.When Enabled, the radio starts sending beacons for the SSID and allowsclients to connect to it.Select Disabled to deactivate the radio. The radio stops sending thebeacons for the SSID.Variable ValueTurbo Mode Specifies the Turbo Mode status. Turbo Mode is used to perform a speedboost to the wireless network.Select Dynamic to allow the BSG to detect whether clients are capable ofTurbo Mode. If a client is not capable of turbo mode, the client returns tonormal mode.Select Static only when you know that all wireless devices in the networkare capable of Turbo Mode.Select Disabled if there are no wireless clients to support turbo mode.The default value is Dynamic.Beacon Period (ms) Type the beacon period.The value ranges from 20 to 1000 ms. The default value is 100 ms.Auto Channel Selection Select this check box to enable automatic channel selection.The default is Enabled.Radio Channel Select the radio channel, if Auto Channel Selection is not enabled.Transmit Power Specifies the transmission power. Select one of the following options:• Full (100%)• Half (50%)• Quarter (25%)• Eigth (12.5%)• MinimumThe default value is Minimum.Maximum Supported Rate Select the link speed of the Radio. Select the maximum supported rate.Options are 1, 2, 5.5, 9, 11, 12, 18, 24, 36, 48, and 54.The default value is 54 Mbps.Variable Value
