132 IP routing advanced configurationNN47928-500NN47928-500RIP neighbor setting configuration parametersRIP neighbors settings specifies a list of router addresses from which you can send or receive RIPpackets.The following section describes the parameters for configuration of RIP interfaces located atConfiguration, IP Routing, RIP, Neighbors Settings tab.RIP Status The admin status of the RIP interface. Select one of the following options:• Enabled - activates the RIP2 process.• Disabled - disables the RIP2 process.• Passive - the RIP2 process runs as a passive process.Split Horizon The operational status of Split Horizon. Select one of the following options:• Split Horizon – split horizon is applied on outgoing response packetsand the route is not sent on an interface from which the route is learnt.• Poisoned Reverse – the route is sent with the metric value as 16 on aninterface from which the route is learnt.• Disabled – the route is sent on all interfaces and the metric is the sameas in the RIP routing table.The default value is Poisoned Reverse.Send Version The version of RIP packets sent by the router. Select one of the followingoptions:• Do not send - indicates that no packets are sent.• RIP Version 1 - indicates the data packets are sent using a RIP updatethat is complaint with RFC 1058.• RIP1 Compatible - indicates the RIP-2 updates are broadcast using anRFC 1058 route subsumption rules.• RIP Version 2 - indicates the RIP2 packets are multicasted.The default value is RIP1 Compatible.Receive Version The RIP packets to receive. Select one of the following options:• RIP1 - indicates only RIPv1 version packets are accepted.• RIP2 - indicates only RIPv2 version packets are accepted.• RIP1 or RIP2 - indicates both RIPv1 and RIPv2 packets are accepted.• Do not receive - indicates that no packets are accepted.The default value is RIP1 or RIP2.Route Age Timer (Seconds) Type the time interval after which the routes are flushed.The value ranges from 30 to 500.The default value is 180.Update Timer (Seconds) Type the time interval between successive RIP updates.The value ranges from 10 to 3600.The default value is 30.Garbage Timer (Seconds) Type the time interval after which the invalid routes are removed from therouting table.The value ranges from 120 to 180.The default value is 120.Variable Value
