VLAN advanced configuration 113Configuration GuideStatic VLAN configuration parametersThe following section describes the parameters for configuration of the static VLAN located atConfiguration, VLAN setup, Static VLAN tab.Variable definitionsThe following table describes the variables and values for configuring static VLAN settings.Tunnel Status Specifies the tunnel status.Select Enable – the data packets received on the port are tunneled.Select Disable – the data packets received on the port are handlednormally.The default value is Disable.To enable 802.1x tunneling on a port, 802.1x (PNAC) Port Control must beset to ForceAuthorized. See Basic port settings configuration parameters(page 197).STP BPDU Tunnel Status Specifies the Spanning Tree Bridge Protocol Data Unit (STP BPDU)Tunnel status.Select Enable – the STP BPDUs packets received on the port are notprocessed but are forwarded like data packets.Select Disable – the packets are handled normally.The default value is Disable.BDTU tunneling status cannot be set if 802.1x tunnel status is disabled.Ingress Filtering Specifies the Ingress Filtering status.Select Enable – the device discards incoming frames for VLANs wherethis port is not a member.Select Disable – the device accepts all incoming frames.The default value is Disable.Port Mode Set Port Mode as Access, Trunk, or Hybrid.The default Port Mode is Hybrid.Variable ValueVLAN ID Type a unique VLAN ID that you want to configure as a static VLAN.VLAN Name Type the VLAN name.Member Ports Type the member port number list for a VLAN.Member ports represent the set of ports permanently assigned to theVLAN egress list. Frames that belong to the specified VLAN are forwardedon the ports in the egress list.Enter a comma separated list of ports or port ranges. For example, 1-6, 9,11.Untagged Ports Type the untagged port number list for a VLAN.Enter a comma separated list of ports or port ranges. For example, 1-6, 9,11.The Untagged Ports list must be a subset of the Member Ports.Variable Value
