140 IP routing advanced configurationNN47928-500NN47928-500RRD configurationRoute Redistribution (RRD) allows different routing protocols to exchange routing information.RRD configuration navigation• RRD basic settings configuration parameters (page 140)• RRD RIP settings configuration parameters (page 140)• RRD OSPF settings configuration parameters (page 141)RRD basic settings configuration parametersThe following section describes the configuration parameters for the RRD basic settings located atConfiguration, IP Routing, RRD, Basic Settings tab.Variable definitionsThe following table describes the variables and values for configuring the RRD basic settings.RRD RIP settings configuration parametersThe following section describes the parameters for configuration of the RRD RIP settings locatedat Configuration, IP Routing, RRD, RIP tab.Variable definitionsThe following table describes the variables and values for configuring RRD RIP settings.Variable ValueRRD Status Select the RRD status as Enabled or Disabled.Select Enabled to enable route redistribution.Select Disabled to disable route redistribution.Router redistribution is allowed only after you set the As Number andRouter ID fields to valid values.AS Number Type the Autonomous System (AS) number of the router.The value ranges from 1 to 65535.The default value is 0.Router ID Type the router ID. The router ID must be one of the IP addresses of theIP interfaces configured in the switch.Variable ValueRIP Status Select the RIP status.Select Enabled to allow route redistribution in the RIP.Select Disabled to stop route redistribution in the RIP.
