Using the BayStack 450 10/100/1000 Series Switch2-22 309978-D Rev 014. Select IP Configuration/Setup (or press i) from the Main Menu.This selection displays the IP Configuration/Setup screen (Figure 2-17).Figure 2-17. IP Configuration/Setup Screen (Stack Configuration)5. Enter the Stack IP address in the In-Band Stack IP Address field, andthen press [Enter].The In-Band Switch IP Address field (directly below the In-Band Stack IPAddress field) is not required for the stack operation. The In-Band Switch IPAddress field allows this switch to operate as a standalone switch. You cannotconfigure both IP address fields to use the same IP address.Note: The default management VLAN (IP interface) for the BayStack 450switch is VLAN 1. However, you can specify which VLAN you want to be themanagement VLAN (see “VLAN Configuration” on page 3-46).IP Configuration/SetupBootP Request Mode: [ BootP Disabled ]Configurable In Use Last BootP------------------- --------------- ---------------In-Band Stack IP Address: [ 0.0.0.0 ] 0.0.0.0In-Band Switch IP Address: [ 0.0.0.0 ] 0.0.0.0In-Band Subnet Mask: [ 0.0.0.0 ] 0.0.0.0 0.0.0.0Default Gateway: [ 0.0.0.0 ] 0.0.0.0 0.0.0.0IP Address to Ping: [ 0.0.0.0 ]Start Ping: [ No ]Use space bar to display choices, press or to select choice.Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.
