Using the Console Interface309978-D Rev 01 3-131Save Current SettingsThe Save Current Settings option (accessed from the main menu) allows you tosave your current configuration settings without resetting your switch or stack.This option is followed by a screen prompt to confirm the action. Enter Yes to saveyour configuration settings; enter No to abort the option. If your switch isparticipating in a stack configuration, additional prompts allow you to save yourconfiguration settings for a specific unit in the stack or for the entire stack.ResetThe Reset option (accessed from the main menu) allows you to reset yourstandalone switch, a specific unit in your stack configuration, or your entire stackwithout erasing any configured switch parameters. Resetting your switch takesapproximately 5 seconds. During this time, your switch initiates a self-test thatcomprises various diagnostic routines and subtests. The LEDs display variouspatterns to indicate that the subtests are in progress. The results of the self-test aredisplayed briefly (5 or 10 seconds) in the Self-Test screen (Figure 3-54), which isfollowed by the Nortel Networks logo screen (Figure 3-55).Figure 3-54. Self-Test Screen After Resetting the SwitchNote: The Self-Test screen for a switch that is participating in a stackconfiguration includes an additional test: Cascade SRAM test. The screenremains displayed only if the self-test detects a fatal error.BayStack 450-xxx Self-TestCPU RAM test ... PassASIC addressing test ... PassASIC buffer RAM test ... PassASIC buffer stack init test ... PassPort internal loopback test ... PassCascade SRAM test ... PassFan test ... PassSelf-test complete.
