Using the Console Interface309978-D Rev 01 3-123LED Indications During the Download ProcessThe software download process automatically completes without userintervention. The process erases the contents of flash memory and replaces it witha new software image. Be careful not to interrupt the download process until afterit runs to completion (the process can take up to 10 minutes, depending onnetwork conditions).When the download process is complete, the switch automatically resets and thenew software image initiates a self-test. The BayStack 450 switch Self-Test screen(see Figure 3-54 on page 3-131) briefly displays the results and is followed by theNortel Networks logo screen. Press [Ctrl]-Y from the Nortel Networks logoscreen to access the BayStack 450 switch main menu.TFTP Server IPAddressThe IP address of your TFTP load host.Default 0.0.0.0 (no IP address assigned)Range Four-octet dotted-decimal notation, where each octet is representedas a decimal value, separated by a decimal pointStart TFTP Loadof New ImageSpecifies whether to start the download of the switch software image (default is No).Use the spacebar to toggle the selection to Yes.Press [Enter] to initiate the software download process.Note: The software download process can take up to 60 seconds to complete (or moreif the load host path is congested or there is a high volume of network traffic).To ensure that the download process is not interrupted, do not power down the switch forapproximately 10 minutes.Default NoRange Yes, NoNote: If problems occur during the software download process, the SoftwareDownload screen displays error codes that define the problem. The error codesare described in Chapter 4, “Troubleshooting.”Table 3-42. Software Download Screen Fields (continued)Field Description
