Chapter 4 Installing CallPilot Mini/CallPilot 150 27CallPilot Mini/CallPilot 150 Installation and Maintenance GuideCallPilot Mini/CallPilot 150 LEDsWhen the CallPilot Mini/CallPilot 150 starts up, the LEDs change to indicate where theCallPilot Mini/CallPilot 150 is in the start up process. Table 6 shows the order in which the LEDschange and describes what each state indicates.When the CallPilot Mini/CallPilot 150 is operating, the LEDs indicate the operating status of theCallPilot interfaces. Table 7 describes the purpose of the LEDs.Table 6 LEDs during startupLEDs Description Indicates1, 2, 3 and 4 turn on. Power is connected to theCallPilot Mini/CallPilot 150 and theRAM test is in progress.1, 2, 3 and 4 turn off. RAM test complete.1, 2, 3 and 4 turn on oneat a time starting with 1. The LEDscontinue to cycle on and off in thisorder.The CallPilot Mini/CallPilot 150 isbeing upgraded.Note: This sequence does not appearevery time you restart CallPilot Mini/CallPilot 150.1, 2, 3 and 4 turn on inorder until all of the LEDs are on. TheLEDs then turn off in the same order.The LEDs continue to cycle on and offin this order.The CallPilot Mini/CallPilot 150 isbooting up.1, 2, 3 and 4 turn off. The CallPilot Mini/CallPilot 150 hasfinished booting up.Note: The LEDs then light to indicateTCM connections as described inTable 7.Table 7 LEDs during operationLED Description LED DescriptionLED lights when TCM channel 4 isconnected to the telephone system.LED lights when the Ethernetconnection is operating at 100 Mbit/sand blinks with Ethernet activity.LED lights when TCM channel 3 isconnected to the telephone system.LED lights when the CallPilot Mini/CallPilot 150 is operating.LED lights when TCM channel 2 isconnected to the telephone system.LED lights when an Ethernetconnection is detected.LED lights when TCM channel 1 isconnected to the telephone system.Not used in this version ofCallPilot Mini/CallPilot 150.Click imagefor anexample.Click imagefor anexample.4321
