Nortel CallPilot Mini Installation And Maintenance Manual

Also see for CallPilot 150: Installation and Maintenance Administration guide Administration guide Quick start guide Administration guide

Contents

Nortel CallPilot Mini Installation And Maintenance Manual Manual pdf 39 page image

Chapter 5 Initializing the CallPilot Mini/CallPilot 150 39CallPilot Mini/CallPilot 150 Installation and Maintenance GuideRunning the Quick Install WizardThe Quick Install Wizard appears the first time you startup CallPilot Manager. The Quick InstallWizard is a single page that gathers enough information to set up a working system. It then appliesthe information and restarts the system.You can reach CallPilot Manager from another computer through a LAN connection, WAN/Internet connection or an Ethernet crossover cable. All of these methods create an IP connectionthat allows you to run CallPilot Manager.Use the following procedure to run the Quick Install Wizard:1 Launch your browser.2 In the URL address box, type the CallPilot Mini/CallPilot 150 IP address.For example: HTTP://192.168.110.10The Quick Install Wizard screen appears. Depending on your system, this can take severalminutes to appear.3 Configure the Quick Install parameters for a CallPilot Mini according to Table 13 on page 39.Configure the Quick Install parameters for a CallPilot 150 according to Table 14 on page 41.Table 13 Quick Install Wizard parameters for a CallPilot MiniNote: You must include HTTP:// to access CallPilot Manager.Field name DescriptionIP Address Enter the IP Address for the CallPilot Mini. If you do not know the IP Address, contactyour network administrator.This is the IP Address you will use to access the CallPilot Mini using CallPilot Manager.Changes to the IP Address take effect when you reboot the CallPilot Mini.If this is a re-install, the IP Address shows the current settings, not the factory default.Subnet Mask Enter the Subnet Mask for the CallPilot Mini. If you do not know the Subnet Mask,contact your network administrator.Changes to the Subnet Mask take effect when you reboot the CallPilot Mini.If this is a re-install, the Subnet Mask shows the current settings, not the factory default.Primary DNS Enter the IP Address of the Primary DNS server that CallPilot Mini uses. If you do notknow the IP Address, contact your network administrator.The Primary DNS server allows you to use domain names, such aswww.nortelnetworks.com, instead of IP addresses when accessing a site.Note: If you do not use DNS, leave this box blank. CallPilot applications, such as DigitalNetworking, can use a DNS server even if you leave this box blank.Secondary DNS Enter the IP Address of the Secondary DNS server that CallPilot Mini uses. If you do notknow the IP Address, contact your network administrator.CallPilot Mini uses the Secondary DNS server if it cannot contact the Primary DNSserver or if the domain name is not listed in the Primary DNS server.Note: If you do not use DNS, leave this box blank. CallPilot applications, such as DigitalNetworking, can use a DNS server even if you leave this box blank.