38 Chapter 5 Initializing the CallPilot Mini/CallPilot 150P0990474 03Changing the IP address using an Ethernet crossover cableUsing an Ethernet crossover cable, you can connect the CallPilot Mini/CallPilot 150 to yourcomputer. With this connection, you can use CallPilot Manager to change the CallPilot Mini/CallPilot 150 IP address before you connect it to the network.To use an Ethernet crossover cable, your computer must be equipped with a 10/100 BaseTEthernet card and support TCP/IP protocol. Figure 5 shows the connections required.Figure 5 Ethernet crossover cableConnecting the Ethernet crossover cable1 Shut down the computer.2 Attach one end of the Ethernet crossover cable to the Ethernet port on the CallPilot Mini/CallPilot 150.3 Connect the other end of the cable to the network interface card on your computer.4 Start the computer.5 Use the Quick Install Wizard to initialize the CallPilot Mini/CallPilot 150.For information about how to use the Quick Install Wizard, refer to “Running the Quick InstallWizard” on page 39.Note: If you do not have access to the CallPilot Mini/CallPilot 150 through the network,you can use an Ethernet crossover cable to configure all of the CallPilot Mini/CallPilot150 parameters.Note: An Ethernet crossover cable is available as a separately available part. Forinformation about obtaining an Ethernet crossover cable, contact your Nortel Networkssupplier.3TD+6TD-1RD+2RD-3TD+6TD-1RD+2RD-
