78 Chapter 10 Off-premise Message NotificationP0919417 02.2Setting up Off-premise Message Notification to a pager numberExample of a destination pager numberIf you are assigning a pager destination number from behind a PBX, remember to insert a ·(depending on your system) before the £ to access an outside line.There is a combined limit of 30 characters for the pager phone number and the pager message.For example, to reach your pager, enter:£›¤fififi⁄¤‹›£‹where:• £ specifies the next digits are special characters• › recognizes dial tone• ¤ specifies that the next digits are the numbers to be dialed• fififi⁄¤‹› is the pager phone number dialed• ‹ inserts a timed pauseDepending on the company supplying your paging service, the programming sequence can vary.For more information about setting the destination phone number parameters for your pager,contact your pager company.To set up Off-premise Message Notification to a pager1 Press ≤ ·°⁄.Follow the voice prompts or the display button options to openyour mailbox.2 If you use the CallPilot interface:• Press °fi to open the Mailbox Tools• Press NOTIF or ¤ to open the Off-premise MessageNotification menu• Go to step 3If you use the Norstar Voice Mail interface:• Press ADMIN or °• Press fl to open the Off-premise Message Notificationmenu• Go to step 33 Press ADMIN or ⁄ to set up Off-premise Message Notification.Msg notifyADMIN SELECT
