INM Broadband Release 4.1 Requirements 165 of 202INM Release 4.1 Planning Guide PG OC 98-13 Issue 1.2• RISC based, 99 MHz clock, 125 MIPS, 45.0 MFLOPS• 512 Mb RAM1• 4 Gig internal hard disk drive (including swap)• 512 Mb of swap space• DDS tape drive (external recommended)• CD ROM• 1 SCSI II port, 5 Mb/s• Two serial ports (RS-232)• 1 parallel port• Ethernet 10-Base-T LAN configuration• PC or HP-HIL keyboardThe minimum hardware requirements for the HP 715/64 1 and B132L+workstations are:• HP-UX 10.20 ACE 1 (July 97)• 19 inch color monitor with 256 colors, 1280 x 1024 pixel resolution and 16megabytes of RAM• RISC based, 64 MHz clock, 78 MIPS, 24 MFLOPS• 256 Mb RAM• 4 Gig internal hard disk drive• 512 Mb of swap space• DDS tape drive (external recommended)• CD ROM• 1 SCSI II port, 5 Mb/s• Two serial ports• 1 parallel port• Ethernet 10-Base-T LAN configuration• PC or HP-HIL keyboardNote: The hardware platforms and minimum hardware configurations forthe INM Broadband Release 4.1 that have been listed above are valid forthe standalone case, in a scalable case as well as in a PA configuration.1Installing any INM 4.1 Building Block component on a HP 715/64 is not supported. The HP 715/64should only be used for the INM 4.1 GUI software.
