Notifier AFP-3030 Programming Manual

Also see for AFP-3030: Operation manual Installation manual Operation manual Installation manual

Contents

Notifier AFP-3030 Programming Manual Manual pdf 88 page image

82 AFP-3030 Programming Manual — P/N DOC-01-032:A 26/06/2015Alter Status Control On/Off Point SelectSoft KeysPOINT: Press this soft key to enter the point address or general zone number (except Z000) to beforced on or off.NEXT/PREVIOUS SELECTION: Press to progress to the next or previous point on the loop, orthe next or previous general zone.ACCEPT: Press to continue to the Control On or Control Off screen.4.5.1 Control OffOne of the following two screens will display when a point or general zone is selected and acceptedin the previous screen.If the selected point or zone is active, the Control Off screen will appear.Figure 4.12 Control Off ScreenSoft KeysFORCE OFF: Press this soft key to change the state of the control module or general zone fromA U T O M A T I C A C T I V E to A U T O M A T I C I N A C T I V E .NOTE: A module with a releasing Type ID can not be forced.C O N T R O L O N / O F FC O N T R O L O N / O F F : N 1 1 4 L 0 3 M 0 5 2A U T O M A T I C A C T I V EE L E V A T O R R E C A L L E A S T W I N GF I F T H F L O O R Z 0 0 0 C O N T R O LF O R C E O F F B A C KNOTE: A module with a releasing Type ID cannot be forced.