OHAUS 7000 Series Instruction Manual

Also see for 7000 Series: Instruction manual Service manual Instruction manual

EN 102 7000 SERIES INDICATORSResetWhen establishing communication between the terminal and system, send a reset command to the terminal toenable a start from a determined state. When the terminal or system is switched on or off, faulty characters can bereceived or sent.Quotation Marks (“ ”)Quotation marks included in the command responses are used to designate fields and will always be sent.Commands and Responses MT-SICS Level 0The terminal receives a command from the system computer and acknowledges the command with an appropriateresponse. The following sections contain a detailed description of the command set in alphabetical order with theassociated responses. Commands and responses are terminated with and . These terminationcharacters are not shown in the following description, but they must always be entered with commands or sent withresponses.The following commands of MT-SICS level 0 are supported:I0 Inquiry of all implemented MT-SICS commandsI1 Inquiry of MT-SICS level and MT-SICS versionsI2 Inquiry of balance dataI3 Inquiry of balance SW version and type definition numberI4 Inquiry of serial numberS Send stable weight valueSI Send weight value immediatelySIR Send weight value immediately and repeatZ Zero@ Reset (clear out serial buffer)The following are detailed descriptions of these Level 0 commands:I0 – INQUIRY OF ALL IMPLEMENTED MT-SICS COMMANDSCommand: I0Response: I0_B_0_“I0” Level 0 “IO” command implementedI0_B_0_“I1” Level 0 “I1” command implementedI0_B_0_“I2” Level 0 “I2” command implementedI0_B_0_“I3” Level 0 “I3” command implementedI0_B_0_“I4” Level 0 “I4” command implementedI0_B_0_“S” Level 0 “S” command implementedI0_B_0_“SI” Level 0 “SI” command implementedI0_B_0_“SIR” Level 0 “SIR” command implementedI0_B_0_“Z” Level 0 “Z” command implementedI0_B_0_“@” Level 0 “@” command implementedI0_B_0_“SR” Level 1 “SR” command implementedI0_B_0_“T” Level 1 “T” command implementedI0_B_0_“TA” Level 1 “TA” command implementedI0_B_0_“TAC” Level 1 “TAC” command implementedResponse: I0_A_1_“TI” Level 1 “TI” command implemented (last command)Response: I0_I Cannot execute command at this time.