OHAUS 7000 Series Instruction Manual

Also see for 7000 Series: Instruction manual Service manual Instruction manual

EN 62 7000 SERIES INDICATORSThe weight display will show dashes, and Line 1 will indicate Working and count down from the programmedSampling Time while the averaging cycle is in process.When the cycle is complete, the averaged weight will be shown on the display, with an asterisk (*) to the leftindicating that it is not a live scale weight. Line 1 will indicate Cycle complete.Press PRINT to print the resulting average weight. The display will return to show the current weight on thescale. If Auto Print is selected, the print will be triggered automatically after the programmed Print Delay time.Remove the animals from the scale. When the weight returns to below 20d, Line 1 will return to the original prompt.Mode 2 OperationBegin with the scale empty and the terminal in the Animal Weighing application.1. The display will prompt Number of animals?2. Press ZERO to capture an accurate zero reference.3. Enter the number of animals to be placed on the scale and the press the ENTER key .4. The display will show Press ENTER to start. or, if Auto Start is enabled, it will prompt Add weight > xxx (i.e.,greater than xxx), where xxx is the programmed threshold weight.5. If required, a transactional ID may be entered via the ID key . If programmed in setup, the ID will appearon Line 2 at the bottom of the display.6. Add the number of animals entered in step 3 to the scale, then press the ENTER key to start the weighingcycle. If Auto Start is enabled, the cycle will start automatically when the weight on the scale exceeds theprogrammed threshold and there is no motion on the scale.7. The weight display will show dashes, and Line 1 will indicate Working and a count down from the programmedSampling Time while the averaging cycle is in process.8. When the cycle is complete, the averaged weight will be shown on the display with an asterisk (*) to the leftindicating that it is not a live scale weight. Line 1 will indicate Cycle complete. If Line 2 has been programmedto do so, it will show the average weight.9. Press PRINT to print the resulting average weight. The display will return to an active weight display. IfAuto Print is selected, the print will be triggered automatically after the programmed hold time.10. Remove the animals from the scale. When the weight returns to below 20d (display divisions), Line 1 willreturn to the original prompt.Aborting a Weighing CycleDuring the animal weighing cycle, the process can be aborted at any time by pressing CLEAR . If operatingin the Auto-start mode, pressing the CLEAR key will revert to manual start for the next cycle.4.2.5 Serial Input CommandsThe Animal Weighing application supports three new serial commands in addition to the standard ASCII commandsfor a demand or continuous connection assignment. These commands are:S Starts the animal weighing process.xxQ Enters a new quantity of animals value. “xx” can be any whole value from 01to 99.E Ends the cycle, clears the display and returns focus to the first screen.