OHAUS 7000 Series Instruction Manual

Also see for 7000 Series: Instruction manual Service manual Instruction manual

7000 SERIES INDICATORS EN 61Start ThresholdThe Start Threshold appears in the menu tree only when Auto Start is Enabled. It defines the scale weight valueabove which the averaging process will begin after stability is reached.Valid settings are from 0 to the full scale capacity. This value should be relatively high – for example, 80% of theestimated weight of all animals on the scale. A very low number may cause the sampling period to start before allthe animals are on the scale.Auto PrintThis Auto Print setting overrides the basic weighing Auto Print function, configured in setup at Scale > Log or Print> Automatic when operating within the application.When Auto Print is enabled, the processed weight value is displayed for the amount of time defined by the PrintDelay setting, and then a transaction print is automatically triggered.This feature can be Enabled or Disabled. By default, it is Disabled.Print DelayPrint Delay is only shown in the menu tree when Auto Print is enabled. It determines the delay between completionof the transaction and triggering the transaction print.Valid settings are from 0 to 10 seconds in 1 second increments. The default value is 5.DisplayLine 2The Line 2 assignment determines what data is displayed during and after a transaction. It is selected from a drop-down list. The selection list varies depending on the Mode selected:SelectionFunctionMode 1 Mode 2Disabled Line 2 is blank.Average Not available Line 2 shows Averageweight per animalID Line 2 shows thetransaction IDLine 2 shows thetransaction IDThe default value is Disabled.4.2.4 Operating SequenceThe following sections describe the two modes of operation of the animal weighing application:Mode 1 Determines the average total weight of a single animal or multipleanimalsMode 2 Determines the average total weight of multiple animals, andcalculates the average weight per animalMode 1 OperationBegin with the scale empty and the terminal in the Animal Weighing application.The display will prompt either Press ENTER to start. In normal operation or if Auto Start is enabled, the system willprompt Add weight > xxx (i.e., greater than xxx), where xxx is the programmed threshold weight.Press ZERO to capture an accurate zero reference.If required, a transactional ID may be entered via the ID key . If programmed in setup, the ID will be shown onLine 2 at the bottom of the display.Add the desired number of animals to the scale and then press the ENTER key to start the weighing cycle. IfAuto Start is enabled, the cycle will start automatically when the weight on the scale exceeds the programmedthreshold and there is no-motion on the scale.