Network Settings 4cm5520 4-113Network Settings Chapter 44.18 Status Notification SettingSpecify settings for sending notification of the machine’s status by e-mail tothe administrator. The status notification is sent if a notification destinatione-mail address is entered and if any of the notification conditions have beenset to “ON”.The following notification addresses can be specified.- IP address- IPX address- E-mail address2 NoteUp to five IP addresses can be specified.If an IP address or IPX address is to be specified, use the TRAP functionwith SNMP. Set “TRAP Setting” on the SNMP Setting screen to “Allow”.For details on “SNMP Settings”, refer to “SNMP Settings” on page 4-92.Specifying an IP addressSettings can be specified for the following.1 Touch [5 Network Setting] in the Administrator Settings screen.– For details on displaying the Administrator Settings screen, refer to“Displaying the Administrator Settings screen” on page 3-7.2 Touch [Fwd.→] in the Network Settings screen, and then touch [1 De-tail Settings].3 Touch [3 Status Notification Setting].The Status Notification Setting screen appears.Parameter DescriptionAddress Specify the notification host address.Port Number Specify the port number to be used for communication. To changethe setting, press the [C] (clear) key, and then use the keypad totype in the desired port number. (Range: 1 to 65535)Community Name Type in the community name (15 characters or less).Notification Item Specify the conditions when notification of the machine’s status issent. For details, refer to “Notification Item” on page 4-120.
