Scan function troubleshooting 5cm5520 5-3Scan function troubleshooting Chapter 55.2 Network error message listIf an error message appears, perform the corresponding operation describedbelow.Message Cause and remedyCannot connect to the network. A connection to the network could not be established.Check if the network cable is correctly connected. In addi-tion, check that the Network Settings parameters in Admin-istrator mode have been correctly specified.The destination cannot be select-ed because the number of desti-nations has exceeded the max.number of broadcasting possible.The number of destinations specified exceeds the numberpossible for a broadcast transmission. Reduce the numberof broadcast destinations, or send the transmission in mul-tiple batches.Image could not be saved in theUser Box due to insufficient HDDcapacity. Check log.The hard disk is full. Delete unnecessary data, and then trysaving the data again.The number of User Boxes hasreached its maximum.The number of user boxes that can be registered hasreached the maximum number possible. Delete unneces-sary user boxes, and then try registering new boxes again.This user box has reached itsmaximum number of pages al-lowed.The number of documents that can be saved in a user boxhas reached the maximum number possible. Delete unnec-essary documents, and then try saving the documentagain.The number of programmed jobshas reached the max. allowance.Wait until a programmed job iscompleted.The number of jobs that can be programmed has reachedthe maximum number possible. Wait until a job has beencompleted, or delete a current job.
