Océ Power Logic®: Settings Editor 1392 Enter the filename without .kos or .sas.3 Click the ‘Save’ button.Note: all settings, key operator and system administrator included, are saved.▼ How to load KO or SA settings from a file1 From the ‘File’ menu, select ‘Open’.You can also click the ‘Open’ button on the top toolbar.The screen displays a dialog box from where you can browse to the requiredfile.2 Click the ‘Apply’ button.The settings are loaded to the system.When you are logged on as a key operator, the system only loads the KOsettings.When you are logged on as a system administrator, the system only loads theSA settings.Repro operators and anonymous users are not authorised to load the settingsfrom a file.Note: this is only possible if the user is logged in as a Key Operator or SystemAdministrator.Find system settings in the Settings EditorThe following table displays all references in this manual that refer to aSettings Editor setting. KO indicate that you must have Key Operatorpermission to change the setting. SA indicates that you must have SystemAdministrator permission to change the setting. Open the ‘File’ menu andselect ‘Logon’ to logon as Key Operator or as System Administrator (seeFigure 64 on page 129).System setting ReferenceonPath in Settings EditorLow power mode timer page 25 KO - System - Timers - Sleep modetimer enable - Low power mode time-outSleep mode timer page 25 KO - System - Timers - Sleep modetimerKO - System - Timers - Sleep modetimer enableShut off timer page 25 KO - System - Timers - Shut-off timeoutWake up timer page 25 KO - System - Wake up
