52 Océ TDS800 User ManualJob templatesA job template contains all settings for a job. Figure 9 on page 49 shows anexample with the following job templates.■ Template 1■ Template 2■ Template 3■ Template 4■ Last usedThe key operator defines the settings in the Océ Settings Editor on the OcéPower Logic controller (see ‘Define the job templates’ on page 137). The keyoperator can change the job template names, except for ‘Last used’, forexample into the following job names.■ Single copy■ Set copy■ Matrix copy■ Scan-to-file■ Last usedWhen you select the ‘Last used’ job template, you recall all settings from theprevious job. You can change the settings or do the same job again. The ‘Lastused’ job template does not display when you turn on the scanner.After you select a template, the sections display. The sections provide accessto the settings for the scanner input, the printer output and the scan-to-fileoutput (see ‘Sections on the display of the scanner operator panel’ on page 49).Use the Custom Card here to provide access to frequently used settingsreffered to the type of job.Change the operator panel languageIt is possible to change the operator panel language. You can choose betweentwo preferred languages. Define the first and second language on the OcéSettings Editor (see ‘Find system settings in the Settings Editor’ on page 139).The Océ TDS800 supports a total of 16 languages. See Chapter 6, ‘Océ PowerLogic®: Settings Editor’ on page 125 and the On-line Help on the Océ SettingsEditor.
