The folder 179FolderThe Océ TDS800 can have a folder to fold your output. The output is foldedaccording to the selected folding width and length with the drawing method.Set the drawing method in the Océ Settings Editor (see ‘Find system settingsin the Settings Editor’ on page 139).Note: You can only fold paper. Polyester, transparent or vellum media cannotbe folded. If you try to fold polyester, transparent or vellum media, a media jamwill occur.Standard folding settings By default, you use the standard folding settingsdefined for your Océ TDS800 system by the key operator. The followingsettings are available:▼ Set the folded copy delivery1 Press the ‘Finishing’ card in the ‘Print’ section.2 Press the function key ‘Folded copy delivery’.3 Select ‘Stacker’ or ‘Belt’.▼ Set folding legend1 Press the ‘Feeding’ card in the ‘Original’ section.2 Press the function key ‘Legend location’.3 Select ‘Leading’ or ‘Trailing’.Note: In the drivers this setting is called the ‘Folding orientation’, with theoptions ‘Portrait’, ‘Landscape’ and ‘Automatic’.▼ Set the drawing method1 Press the ‘Feeding’ card in the ‘Original’ section.2 Press the function key ‘Drawing method’.3 Select ‘Standard’, ‘Ericsson’ or ‘Afnor’.▼ Set the folded package width1 Press the ‘Finishing’ card in the ‘Print’ section.2 Press the function key ‘Folded package’.3 Select ‘Width’.4 Enter a range between 186 - 230 mm or 7.3 - 9 inch, in steps of 1 mm or 0.1inch; default 210 mm or 9 inch.
