1 Before making copies1-36 cm5520Before making copies Chapter 12 ReminderWhen the machine is turned off, then on again with the main powerswitch, wait at least 10 seconds to turn the machine on after turning it off.The machine may not operate correctly if it is turned on immediately afterbeing turned off.Do not turn off the machine with the main power switch or the [Power](auxiliary power) key while it is making copies or printing, otherwise a pa-per misfeed may occur.Do not turn off the machine with the main power switch or the [Power](auxiliary power) key while it is scanning or sending or receiving data, oth-erwise all scan data or transmission data will be deleted.Do not turn off the machine with the main power switch while a queuedjob or stored data is waiting to be printed, otherwise the jobs will be de-leted.!DetailThe following are cleared when the main power switch and [Power] (aux-iliary power) key are turned off.Settings that have not been programmedJobs queued to be printedAutomatically clearing settings (automatic panel reset)If no operation is performed for a specified length of time (even if the [Reset]key is not pressed), settings that have not been programmed, such as thenumber of copies, are cleared and return to their default settings.This is the automatic panel reset operation.As the factory default, the automatic panel reset operation is performed after1 minute.!DetailThe length of time until the automatic panel reset operation is performedand whether or not it is performed can be set from Utility mode. For de-tails, refer to “System Settings” on page 11-30.Whether or not the automatic panel reset operation is performed whenthere is a change of user can be set from the Utility mode. For details, re-fer to “System Settings” on page 11-30.