Troubleshooting and routine maintenance103The machine prints the first coupleof pages correctly, then somepages have text missing. Check the settings in your application to make sure that it is set up to work withyour machine Your computer is not recognizing the machine’s input buffer’s full signal. Makesure that you connected the interface cable correctly.(See the Quick Setup Guide.)The machine cannot print fullpages of a document.Out of Memory messageappears. Reduce the printing resolution. (See Advanced tab in the Software User’sGuide on the CD-ROM.) Reduce the complexity of your document and try again. Reduce the graphicquality or the number of font sizes within your application. Add more memory. See Installing extra memory on page 99.The headers or footers appearwhen the document displays on thescreen but they do not show upwhen it is printed.There is an unprintable area on the top and bottom of the page. Adjust the top andbottom margins in your document to allow for this.The machine does not print on bothsides of the paper even though theprinter driver setting is Duplex.Check the paper size setting in the printer driver. You need to choose A4, Letter,Legal or Folio.The machine is not printing or hasstopped printing and the machine’sstatus LED is yellow.Press Job Cancel.As the machine cancels the Job and clears it from the memory it may produce anincomplete printout.Scanning DifficultiesDifficulties SuggestionsTWAIN errors appear whilescanning. Make sure that the TWAIN driver is chosen as the primary source. In PaperPort ® ,click File, Scan and choose the TWAIN driver.Software DifficultiesDifficulties SuggestionsCannot install software or print. Run the Repair Multi-Function Suite program on the CD-ROM. This program willrepair and reinstall the software.Cannot perform ‘2 in 1’ or ‘4 in 1’printing.Check that the paper size setting in the application and in the printer driver are thesame.The machine does not print fromAdobe Illustrator.Try to reduce the print resolution. (See Advanced tab in the Software User’s Guideon the CD-ROM.)When using ATM fonts, somecharacters are missing or wrongcharacters are printed in theirplace.If you are using Windows ® 98/98SE/Me, click Start, Settings, and then Printers.Right-click Océ fx3000 and click Properties. Click Spool Setting on the Detailstab. Choose RAW from Spool Data Format.Printing Difficulties (Continued)Difficulties Suggestions