Transmission Applications 7Network Fax 7-25Transmission Applications Chapter 77.10 TX StampTX StampWhen transmitting a fax via the ADF, a stamp can be affixed to the pages ofthe document that have already been scanned, allowing you to confirm thatthese pages have been scanned. The stamp is a pink circle ( ), 4 mm indiameter and affixed at the rear edge on the front side of the originaldocument. When both sides of a sheet are transmitted, the stamp is affixedrespectively on the front side.0SpecificationsCan be used only when the stamp unit is installed.The stamp ink must be replaced when it runs out. When color of theverification stamp becomes light, contact your service representative fora replacement.When mixed original mode is selected, no stamp may be affixed to theabove position.Even though the TX Stamp function has been set, no TX Stamp is put ifthe document is transmitted in the multi-feeding. In such a case, transmitthe document again.Check if the document was correctly transmitted by the TransmissionReport or Transmit Result of the CHECK MODE.1 Press [Fax] on the control panel to view the FAX screen, if it is notalready displayed.2 Press [Scan Setting] and then press [Application].Stamp positionFront surface oforiginal documentOriginal documenttransmitting direction
