1 - 96Chapter 1 TroubleshootingFIP-1.P10 AfterimageTrouble substanceThe ghost appears on the paper. The ghost may be the image of the previouspage, or a part of the page currently printing.ESS and possible causative parts- EP CARTRIDGE- HVPS/MCU (PL12.1.19)- GUIDE ASSY CRU R (PL8.1.25)- Drive Assy- BTR ASSY (PL8.1.21)- 150 FEEDER ASSY (PL5.1.1)- MAIN MOTOR (PL11.1.2)- GEAR ASSY HOUSING (PL11.1.3)- PWBA ESS (PL12.1.13)- FUSER ASSY (PL8.1.20)- Heat Roll- Pressure Roll- 250 FEEDER ASSY (PL6.1.11)- 550 FEEDER ASSY (PL7.1.10)Before commencing troubleshooting, check the paper transfer course. Make sure there is no foreignarticles on the transfer course, such as staples, paper clips, scraps of paper and so on.Step Check Yes No1Checking repeat printingCheck the afterimage.Is the client printing a copy of the same image in a largequantity?Go to step 2. Go to step 3.2 Print 30 pages of the image of every kind.Does the afterimage still appear? Go to step 3.Don’t make acopy of the sameimage in a largequantity.3Checking the paper conditionHave new, dry and recommended paper on.Re-print the problem image.Does the problem still occur?Go to step 4. End of work4Checking EP CARTRIDGEInstall a new EP CARTRIDGE.Re-print the problem image.Does the problem still occur?Go to step 5. End of work5Checking BTR ASSYRemove BTR ASSY. (RRP8.10)Check if any stains and/or wear on BTR ASSY.Are there any stains and/or wear on BTR?Go to step 6.Replace BTRASSY.(RRP8.10)
