1 - 33Chapter 1 TroubleshootingFIP1.9 Paper Jam/Tray to RegiStep Check Yes NoPossible causative parts:150 FEEDER ASSY (PL5.1.1)150 PAPER CASSETTE (PL2.1.50)SENSOR REGI (PL5.1.30)ACTUATOR B (PL5.1.17)CHUTE ASSY FDR1 (PL5.1.3)HVPS/MCU (PL12.1.19)LVPS (PL12.1.5)CHUTE ASSY FDR2 (PL6.1.22, PL7.1.21, PL20.2.2)CLUTCH ASSY PH (PL5.1.21, PL6.1.21, PL7.1.20,PL20.2.21)ROLL ASSY RETARD (PL2.1.2, PL3.1.2, PL4.1.2,PL20.3.2)CLUTCH PR-REGI (PL20.2.22)550 FEEDER OPION (PL20.2.1)250 FEEDER ASSY (PL6.1.11)250 PAPER CASSETTE (PL3.1.50)550 FEEDER ASSY (PL7.1.10)550 PAPER CASSETTE (PL4.1.50)1Checking the paper size setupDoes the paper size in use match the size setup by GUIDEASSY END or by the driver on the PC?Go to step 2.Replace thepaper, or changethe paper sizesetup.2 Does Error occur when the power is turned ON? Go to step 3. Go to step 5.3Checking the paper at ACTUATOR BDoes the paper remain at ACTUATOR B of SENSORREGI?Remove thepaper, and go tostep 4.Go to FIP2.5SENSOR REGI.4 Does Error occur when the power is turned ON? Go to FIP2.5SENSOR REGI. Go to step 5.5Checking ROLL ASSY RETARDIs ROLL ASSY RETARD not damaged, and installedcorrectly?Check the operation of it assembled each Paper Cassette.Go to step 6.Replace ROLLASSY RETARD(RRP2.1, 3.1, 4.1,20.17)6Carrying out a test printingDoes Error occur, when the test printing is done with thepaper supplied from the Tray 1 or Tray 2?With the Option 550 Paper Feeder is installed, does Erroroccur, when the test printing is done with the papersupplied from the Tray 3 or Tray 4?Checks by Chapter 2 Diagnostic [TEST PATTERN MODEMENU].Go to step 7. End of work7Checking the paper positionRemove EP CARTRIDGE.Does the front end of paper touch Actuator B of SENSORREGI?Go to step 8. Go to FIP2.5SENSOR REGI.
