1 - 31Chapter 1 TroubleshootingFIP1.8 Paper Jam/ExitStep Check Yes NoPossible causative parts:FUSER ASSY (PL8.1.20)HVPS/MCU (PL12.1.19)HARNESS ASSY FUSER (PL8.1.17)MOTOR ASSY EXIT (PL10.1.15)LVPS (PL12.1.5)ROLL PINCH EXIT (PL10.1.23)CHUTE LW EXT2 ASSY (PL9.1.2)500 EXIT ASSY (PL10.1.2)150 PAPER CASSETTE (PL2.1.50)250 PAPER CASSETTE (PL3.1.50)550 PAPER CASSETTE (PL4.1.50)1 Checking the paper conditionIs the paper crumpled, damaged or damp?Replace thepaper with a newand dry one.Go to step 2.2Checking the paper size setupDoes the paper size in use match the size setup by GUIDEASSY END or by the driver on the PC?Go to step 3.Replace thepaper, or set upthe paper sizecorrectly.3 Does Error occur when the power is turned ON? Go to step 4. Go to step 6.4 Checking the paper in Actuator ExitIs there any remaining paper in Actuator Exit?Remove thepaper, and go tostep 5.Go to step 8.5 Does Error occur when the power is turned ON? Go to step 8. Go to step 6.6Carrying out a test printingDoes Error occur?Checks by Chapter 2 Diagnostic [TEST PATTERN MODEMENU].Go to step 7. End of work7Checking ROLL PINCH EXITRemove COVER TOP ASSY (PL1.1.7). (RRP1.4)Is ROLL PINCH EXIT not damaged, and rotatingsmoothly?Does SPRING PINCH EXIT attach?Turn ROLL EXIT with a finger to check.Go to step 8. Replace ROLLPINCH EXIT.8Checking ROLL EXIT (PL9.1.19) for rotationRemove EP CARTRIDGE.Close COVER OPEN (PL1.1.2).Turn the power ON.Does ROLL EXIT rotate smoothly during warm up?Go to step 9.Replace CHUTELW EXT2 ASSY.(RRP9.1)9Checking Actuator Exit for operationRemove EP CARTRIDGE.Does Actuator Exit move smoothly, when touchingActuator Exit with a finger inserted from the exit of FUSERASSY, and moving it up and down?With toolGo to step 10.Without toolGo to step 11.Replace FUSERASSY. (RRP8.8)
