2 - 28Chapter 2 Operation of DiagnosticDC612 PatternPrtDescription: Prints a test pattern output from a pattern generator built into the machine.• The message that printing is in progress is displayed on the message area duringpattern output.• Perform jam/fail detection. If any error is detected, an operation stops in the sameway as the normal mode, but a message of Recovery is not shown. If a failureoccurs, a chain-link No. is shown, but History is disabled.Prepare paper in the tray in advance.Procedure:1. Enter the Diag (C/E) mode, and select [Diag. Menu Fault Diag.] in the same hierarchical level usingthe " ↓ " key.2. Select the [Fault Diag. DC140 Monitor] screen in a lower level using the " → " key.3. Select [Fault Diag. DC612 PatternPrt] in the same hierarchical level using the " ↓ " key.4. Select the setting item screen [DC612 PatternPrt Qty 01] using the " → " key.If you want to execute an output without changing any setting item, press the " ↓ "key several times until [DC612 PatternPrt If OK press SEL] is shown, and press the"FEED / SELECT" key to execute a test pattern output.5. Show the number of copies screen using the " → " key.6. Specify the number of copies to output.• To set the number of copies, move the cursor using the " ← " or " → " key and change anumerical value using the " ↑ " or " ↓ " key.When the cursor is positioned at the left end of the copies field, pressing the " ← "key allows you to return to the [DC612 PatternPrt Qty 01] screen in an upperhierarchical level.7. The number of copies is fixed by pressing the "FEED / SELECT" key. Then, "*" is marked at theright end of the copies field.8. Select the setting item screen [DC612 PatternPrt Tray Tray 1] using the " ↑ " or " ↓ " key.Quantity01
