SpecificationsAppendixPrinting3Setting Up2Before use1 Basic Device Operations4 Index- 132 -Network interface specificationz Basic specificationsNetwork protocolsz For TCP/IPz For EtherTalkz Connectors1000BASE-T / 100 BASE-TX / 10 BASE-T (Auto switching and simultaneous use are not possible)Notez The default factory setting is to disable 1000BASE-T.If using with 1000BASE-T, use the control panel to make the following settings.Set to [Administrator menu]> [Enter password> [Network Setup]> Gigabit Network]> [Enable].z CablesUnshielded twist pair cable with EJ-45 connector (category 5e or later)z Connector pin arrayz Interface signalsPinNo.SignalnameFunction1 TRD+(0) Data 0 sending and receiving (+)2 TRD-(0) Data 0 sending and receiving (-)3 TRD+(1) Data 1 sending and receiving (+)4 TRD+(2) Data 2 sending and receiving (+)5 TRD-(2) Data 2 sending and receiving (-)6 TRD-(1) Data 1 sending and receiving (-)7 TRD+(3) Data 3 sending and receiving (+)8 TRD-(3) Data 3 sending and receiving (-)
