- 58 -Connecting the PCAppendixPrinting3Setting Up2Before use1 Basic Device Operations4 IndexConnecting Using USB CablesConnect the device and PC using USB cables.USB cable PreparationsUSB cableNote USB cables are not enclosed with the device. Prepare USBcables with USB2.0 specifications, length 2m max. asnecessary. If connecting using USB2.0 Hi-Speed mode, use a USBcable with Hi-Speed USB2.0 specifications. Connecting USB CablesNote If the printer drivers are not installed on the PC, removethe USB cable fromthe PC, and first install the printerdrivers. (page 66)1 Pay attention to the connectororientation, and connect the square endof the USB cable to the Printer ( ).Connect the other, flat end to the PC ( ).USB cableUSB interfaceconnectorUSB portNote Be careful not to insert the USB cable into the LAN(network) interface connector. Doing so may cause aprinter malfunction. Do not insert the USB cable when the PC or device powersupply is ON. Doing so may cause a printer malfunction.Memo Set the device USB baud rate using the control panelaccording to the USB port baud rate (speed) mountedto the PC. For the control panel, see “Control PanelAppearance” (P.25).
