- 52 -Turning ON/OFF the PowerAppendixPrinting3Setting Up2Before use1 Basic Device Operations4 IndexTurning OFF the PowerSupplyDuring normal use, use the following procedureto turn OFF the power supply.Note Once shutdown has been implemented, it cannot bestopped. To turn ON the device power supply again, waituntil shutdown has finished, and then turn ON the powersupply.1 Press and hold the power switch forapprox. 1s."Shutting down. Please wait. Powerwill turn OFF automatically" will bedisplayed in the control panel, and thepower switch LED lamp will flash on anapprox. 1-s cycle.Wait a moment, and the powersupply for the device will turn OFFautomatically, and the LED lamp on thepower switch will turn OFF.Note Press and hold the power switch for 5s min. to force-turnOFF the power supply. Use only if a problem has occurred.For device problems, see "Troubleshooting/DailyMaintenance Manual".In the following cases, use the followingprocedure to turn OFF the main power supply.If not using the device for long periods overholidays or during travel, etc.If mounting optional or maintenance products.If moving the device.If implementing device repairs or inspections,etc.1 Press and hold the power switch forapprox. 1s."Shutting down. Please wait. Powerwill turn OFF automatically" will bedisplayed in the control panel, and thepower switch LED lamp will flash on anapprox. 1-s cycle.Wait a moment, and the device powersupply will turn OFF automatically, andthe LED lamp on the power switch willturn OFF.2 Turn the main power supply switch tothe OFF (O) position to turn OFF thepower supply.
