77-3 Setting passwordsPasswords from the Control PanelFor more information on Administrator access privileges, see page 3-3. Forinformation on controlling print jobs with the job management tools, see theJob Management Guide.N OTE : The Operator password can be set and changed only from Fiery WebSetup, orCommand WorkStation.T O CHANGE THE F IERY PASSWORDNew PasswordUse the and keys to select the characters and the ENTER key to advance to thenext character position. When the last character has been entered (ENTER keypressed) password entry is complete. The password can be any combination of lettersand numbers up to 19 characters.Caution: If you decide to set an administrator password make sure you keep acareful note of it. If you lose or forget this password it cannot berecovered for you, and the internal hard disk drive containing theoperating system and all settings will need to be replaced.Verify New PasswordReenter the new password, exactly as you entered it initially. If you make a mistake,you are prompted to enter the password again. The new password is effective after yousave changes and restart the Fiery.1. Scroll through the main Setup menu and choose Change Password.2. Enter and confirm the password, as follows.
