44-11 Network Setup optionsProtocol Setup optionsAppleTalk ZoneList of zonesThe Fiery searches the network for AppleTalk zones in your network segment. Scrollthrough the list to select the AppleTalk zone in which you want the Fiery to appear.If your segment has only one zone, the Fiery is assigned to that zone automatically.The message “No AppleTalk zone found” may mean your network has no zones, or thenetwork cable is not connected (see Appendix A).TCP/IP Setup optionsWhen you set an IP address, subnet mask, or gateway address for the Fiery duringSetup, you can allow the Fiery to get these addresses automatically from a DHCP orBOOTP server. First, turn on or restart the Fiery and allow it to reach Idle. Make surethe DHCP or BOOTP server is running, and then perform Fiery Setup.To configure the Fiery, choose each protocol and enter the settings for thatprotocol. You can enable AppleTalk, TCP/IP, and IPX/SPX communicationsimultaneously.Network SetupProtocol Setup AppleTalk SetupEnable AppleTalkYes/No [Yes]Select Yes if you have an AppleTalk network connected to the Fiery. This settingenables the Fiery to communicate over AppleTalk networks.To configure the Fiery for TCP/IP, choose TCP/IP Setup.Choose Ethernet Setup and enter the appropriate settings. Choose each networktype you use (Ethernet) and enter the appropriate settings.
